GE RSTi-EP - Resetting the Web Server; Resetting the Network Adapter to Factory Settings

Chapter 8 Web Server
GFK-2958E RSTi-EP User Manual 369
9.6.1 Resetting the Web Server
You can undo all the changes that have been made since the last time that the web server was
started.
Note: After a reset, the network adapter is restarted. All data not protected against power failure is
reset.
➢ To reset the web server
1. Click on the network adapter.
2. From the Network Adapter Status dialog box, click Reset.
3. To reset changes that have been made, respond to the prompt by clicking Yes.
9.6.2 Resetting the Network Adapter to Factory Settings
This function allows you to set up the web server in its original state as at delivery. This also includes
registration data and password protection.
➢ To reset the network adapter to factory settings
1. Click on the network adapter.
2. From the Network Adapter Status dialog box, click Factory settings.
3. Click Yes to confirm that you would like to reset the network adapter to the factory settings.