GE RSTi-EP

Chapter 3: Configuration
GFK-2958E RSTi-EP User Manual 36
3.9 Parameter Overview
Overview of the Editable Parameters
Product
Part No.
Parameter
Optional values
Default value
PROFIBUS DP-V1
Network Adapter
EPXPBS001
DP-Alarm mode
V0 / V1
V1
DP alarm mode V0
For mode V0, the alarm triggers are set in
the parameter data.
Diagnostic alarm
†
enabled / disabled
disabled
Process alarm
†
enabled / disabled
disabled
Hot-plug alarm
†
enabled / disabled
enabled
†
These switches are always selectable, but they only have a function in mode
V0. Diagnostic messages are generated which are not acknowledged by the
PLC.
DP alarm mode V1
In mode V1, the alarm triggers are set in
the engineering environment.
Diagnostic alarm
††
enabled / disabled
disabled
Process alarm
††
enabled / disabled
disabled
Hot-plug alarm
††
enabled / disabled
enabled
††
These switches can be selected only in mode V1, in V0 they are inactive.
Diagnostic messages are generated which are acknowledged by the PLC.
Identifier-related diagnosis
†††
enabled / disabled
enabled
Channel-related diagnosis
†††
enabled / disabled
enabled
Module status
†††
enabled / disabled
enabled
†††
A diagnostic block is attached to the diagnostic message.
Data format
Motorola / Intel
Motorola
Fieldbus error output behavior
All outputs off /
activate replacement
values / retain last
value
All outputs off
Module behavior during hot
swap
Continue data
exchange /
behavior as with
fieldbus error
Continue data
exchange
Product
Part No.
Parameter
Optional values
Default value
PROFINET IRT
Network Adapter, 2
Cu RJ45 Ports, 1024
bytes (Input + Output)
EPXPNS001
Process alarm
enabled / disabled
disabled
Diagnostic alarm
enabled / disabled
disabled
Type of diagnostic
Extended channel
diagnostic (short
diagnostic)
Manufacturer-
specific diagnostic
(complete
diagnostic)
Extended channel
diagnostic
(short diagnostic)
Behavior of outputs on fieldbus
errors
All outputs off /
Enable substitute
value / Hold
last value
All outputs off