GFK-2958E RSTi-EP User Manual 321
5. Slide the module to the left until it audibly clicks into place on the bus network adapter. At the
same time, press the module as close as possible to the DIN rail so that the module is not
tilted.
Sliding the Module into Position
6. Attach all of the other modules as described above.
7. Connect the second end bracket to the end plate as specified by the alignment pins.
8. Place both parts on the DIN rail on the right-hand side of the station so that the end bracket
faces outwards.
9. Slide the end bracket and end plate to the left until it completely connects with the last
module.
Sliding the End Plate with End Bracket into Position
10. Screw down the end bracket tightly (using a 3-mm screwdriver).
11. Make sure that all release levers are in the locking position as standard. If this is not the case,
click the open release lever into place.
To Next Page
Loading...
