Rack and pinion hoist
Assembly and Operating Instructions
12 / 100 BL108 GB Edition 03.2018 Rev. 02
1.6.1 Requirements of assembly personnel
The machine must only be assembled, operated and maintained by
competent persons who, based on their training or knowledge and
practical experience, can ensure correct handling and who are
instructed about the risks associated with the construction hoist. These
persons must be appointed to the tasks of installation, dismantling and
maintenance by the operating company.
1.6.2 Operating personnel
The machine may be operated only by persons who, based on their
training, knowledge and practical experience, can guarantee proper
handling.
These persons must
− have been appointed by the operating company.
− have been appropriately instructed and informed about the risks.
− Be acquainted with the assembly and operating manual.
− observe national regulations
1.6.3 Improper use
• Transporting persons is prohibited!
− Only authorised persons are permitted to travel on the load platform
and only for the purposes of assembly and servicing tasks. Special
measures are required for such operations.
− Use the front fall protection.
− Operation during assembly work may only be carried out using the
assembly control from the load platform.
• The 200 Z is not designed for permanent installation.
• The 200 Z must not be constructed to be free-standing (without anchors).
• Persons who have not been instructed in the machine and who are
not acquainted with the operating manual, and children, may not
operate the machine.
Consequences of improper use of equipment
− Danger to life and limb of the user or a third party.
− Damage to the machine and other tangible assets.
To Next Page
Loading...