Rack and pinion hoist
Assembly and Operating Instructions
55 / 100 BL108 GB Edition 03.2018 Rev. 02
6 Operation
The GEDA 200 Z may only be operated by a qualified person
appointed by the operating company. This person must be familiar
with the operating manual, have sufficient experience and be
informed about the risks involved in handling the hoisting
equipment.
Operating personnel see section 1.6.2
6.1 Safety during operation
• Also observe the safety notes in Chapter 2.4.
• Transporting persons is prohibited!
− It is permitted to ride on the load
platform to carry out assembly and
servicing tasks.
• Operation must be from outside the danger area.
• The operator must always be able to monitor the platform.
• Particular care is required near ground level.
• Load the platform as centrally as possible, observe the load capacity
of the machine.
− The load platform must always be loaded in such a way that the
platform access points are kept clear.
− Position the load securely on the load platform.
− Material that might tend to slip or is higher than the load platform, or
which could fall over, must be secured (consider the possibility of
sudden winds).
− Do not transport bulky goods that project over the side of the
platform.
• Do not stand or work beneath the load platform!
• Do not place objects under the load platform.
− Store material at a safety distance of min. 50 cm from moving parts
of the machine.
• Landing level safety gates may only be unlocked and opened when the
load platform is turned and when using the key secured to the gate.
• If the loaded platform stops due to a malfunction during operation,
the operator must recover the load. -Never leave a loaded load
platform unattended!
• Load platform operation must cease when:
− Wind speeds are over 72 km/h (20 m/sec. ≈ wind force 7-8 according
to the Beaufort scale).
− Temperatures of less than -20°C and more than +40 °C.
− there is damage or other malfunctions.
− recurring check is not carried out (see Chapter 8.2).
To Next Page
Loading...