Rack and pinion hoist
Assembly and Operating Instructions
48 / 100 BL108 GB Edition 03.2018 Rev. 02
5.3.3 Assembling the platform
Insert the platform (1) on the
rectangular tubes (2) of the
turning unit and push towards the
trolley until you hear it engage
with the interlock lever (3) on the
underside of the load platform.
Figure of swivelling frame (2),
installed on the right.
If the swivelling frame (2) is
installed on the left-hand side of
the trolley, the load platform must
be installed rotated through 180°.
To dismantle the platform (1) pull
out the interlock lever (3) and pull
the platform (1) out of the
rectangular tubes.
Pivot the platform.
Fix the cable from the loading-
ramp limit switch of the load
platform to the cable holder using
the grommet (4) and plug the
connector in at the free plug
socket (6) on the trolley switch
box.
To Next Page
Loading...