page | 90
7. Enter the delay (in milliseconds) in the Delay eld. This value represents the number
of milliseconds before the next command is executed. For this example, we will leave
the Delay set to the default value of 250.
The maximum value is 9999 (approximately 10 seconds).
8. Click the Add command button to add another command. Fill in the information for
the A/V Receiver, as shown below.
Creating Macros
Using the GAVA Wizard
Value
Enter a value, if required.
Delay
The number of milliseconds
before the next command in the
list is executed.
Add command
Adds a new device command to the current
macro.
To Next Page
Loading...