Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 139
C02.15 AI 2 filter [sec] RWS 0.0064 0.00/4.096 PP V-F-S-B Full 5026
Time constant of the Analog Input 2 filter.
C02.16 AI 2 low lim [cnt] RWS -16384 -32768/32767 PP V-F-S-B Full 5027
Lower limit of the Analog Input 2 block output in count (see figure of Analog Input 1).
C02.17 AI 2 hi lim [cnt] RWS 16383 -32768/32767 PP V-F-S-B Full 5028
Upper limit of the Analog Input 2 block output in count (see figure of Analog Input 1).
C02.18 AI 2 offs tune / Start?
Autotune command for the Analog Input 2 offset. Input automatic fine-tuning.
To run the autotune, put the input signal to its minimum value and execute “Start ?”
command.
C02.19 AI 2 gain tune / Start?
Autotune command for the Analog Input 2 gain.
Conditions containing an offset can be compensated. To run the autotune, put the input
signal to its maximum value and execute “Start ?” command.
C02.20 AI 2 output [cnt] R 0.00 -32768/32767 PV V-F-S-B Easy 5029
Analog Input 2 output count displaying.
C02.21 AI 2 < thr N/A R 0 0/1 DV V-F-S-B Full 5030
Display of threshold compensator state of Analog Input 2 (1 = the condition is true).
C02.22 AI 2 gain N/A RWS 1 -16/16 PP V-F-S-B Full 5025
Analog Input 2 gain count value displaying.
C03 INTERFACE / An Inp 3
See Analog Input 1 diagram and description details above.
C03.00 AI 3 sgn src N/A RWS Ipa4000 PList 3 PIN V-F-S-B Full 5051
Ipa 4000 - NULL = Default
It connects the selected signal to the selector of the multiplier input: if the signal is 0,
multiply by +1, or if the signal is 1, multiply by -1. The multiplier allows to invert Analog
Input 3 signal.
ªª
ªª
ª
Pick List 3
To Next Page
Loading...
