GEFRAN-SIEI ARTDrive Vector V2 Series - Page 176

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 176 ARTDrive V2 series - Instruction Manual


 REF&RAMP / MRamp src
This Block allows to select 4 different sets of the Ramp times. Each ramp time set
allows to set the acceleration and deceleration times of the Ramp and of the S-Ramp and
the deceleration time of the Fast Stop. The Block has two input sources: Multi Ramp s0
src and Multi ramp s1 src.
According to the state of the signals connected to the sources, it is possible to select one
of the output Multi Ramp Sets.
CTRL
.
.
.
.
.
.
.
.
SET0
Acc Filter
Dec Slope
Acc Slope
Dec Filter
SET1SET2SET3
Encoding
Mlt ramp s0 src
NULL
Mlt ramp s1 src
NULL
Accel time 1
10 s
Decel time 1
10 s
Fdec time 1
10 s
Acc S curve 1
0,1 s
Dec S curve 1
0,1 s
Accel time 2
10 s
Decel time 2
10 s
Fdec time 2
10 s
Acc S curve 2
0,1 s
Dec S curve 2
0,1 s
Accel time 3
10 s
Decel time 3
10 s
Fdec time 3
10 s
Acc S curve 3
0,1 s
Dec S curve 3
0,1 s
Accel time 4
10 s
Decel time 4
10 s
Fdec time 4
10 s
Acc S curve 4
0,1 s
Dec S curve 4
0,1 s
MltRampSet act
FStop SM mon
Figure D01: Multiramp block
The ramp control can be set for a programmable delay for the acceleration and
deceleration times of the drive reference. This delay time will have to be set on the final
system (motor and load), being strictly dependant from the inertia of the load machine.
The time values are expressed in seconds.
The ramps time delay are calculated in accordance with the B0E.00 - Full scale speed
parameter.
D01 REF&RAMP / MRamp src
D01.00 Mlt ramp s0 src N/A RWS Ipa4000 PList 3 PIN V-F-S-B Easy 8090
Ipa 4000 - NULL = Default
Multi ramp selector 0 source: it allows to select the origin of the signals stating the input
combination.
ªª
ªª
ª
Pick List 3