GEFRAN-SIEI ARTDrive Vector V2 Series - Page 181

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 181
D07.10 Ramp out enable N/A WSZ 1 0/1 DP V-F-S-B Easy 8031
[0] Disabled
[1] Enabled
Ramp function enabling
D07.11 Ramp shape N/A RWS 1 0/1 DV V-F-S-B Easy 8021
[0] Linear
[1] S-Shaped
Ramp selection. Linear or S-shaped ramp
D07.20 Ramp out mon [rpm] R 0.00 0.00/0.00 PV V-F-S-B Easy 8022
Displaying of the Ramp output signal
D07.21 Ramp Acc state N/A R 0 0/1 DV V-F-S-B Full 8023
Displaying of the Ramp acceleration state signal:
0= Not acceleration
1 = Acceleration
D07.22 Ramp Dec state N/A R 0 0/1 DV V-F-S-B Full 8024
Displaying of the Ramp deceleration state signal:
0= Not deceleration
1 = Deceleration
D07.23 Ramp out = 0 N/A R 0 0/1 DV V-F-S-B Full 8025
Ramp output signal different from zero:
0 = Ramp enabled
1 = Ramp disabled
D07.24 Ramp cmds mon N/A R 0 0/15 DP V-F-S-B Full 8026
Command monitor for the ramp block:
Bit 0 -> Ramp output = 0, if ONE the value is 1
Bit 1 -> Ramp input = 0, if ONE the value is 2
Bit 2 -> Ramp freeze, if ONE the value is 4
Bit 3 -> Ramp out enable