GEFRAN-SIEI ARTDrive Vector V2 Series - Page 182

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 182 ARTDrive V2 series - Instruction Manual


 REF&RAMP / Mlt speed
This Block allows to set up to 8 Internal Speed references, one of which is supplied with
the Speed 0 reference function.
Three selection inputs allow to activate on the output the desired Speed.
Through the D08.00 - MltSpd sel 0 src, D08.01 - MltSpd sel 1 src, D08.02 - MltSpd sel
2 src sources, it is possible to select the origin of the signals stating the input
combination (they are standard connected to NULL).
The D08.03 - MltSpd 0 src and D08.04 - MltSpd 1 src sources states the origin of the
Speed 0 and Speed 1 reference signal (it is standard connected to Mlt spd 0 and to Mlt
spd 1).
The 8 chosen speeds can be set in the configurations via Mlt spd 0 .. 7.
The following table lists the possible combinations of the three inputs stating the active
Speed (0-7):
MltSpd sel 2 src MltSpd sel 1 src MltSpd sel 0 src ACTIVE SPEED
0 0 0 Multi speed 0
0 0 1 Multi speed 1
0 1 0 Multi speed 2
0 1 1 Multi speed 3
1 0 0 Multi speed 4
1 0 1 Multi speed 5
1 1 0 Multi speed 6
1 1 1 Multi speed 7
tab_D08
Table D08: Multi speed combinations
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
7
Mlt
Speed 7
6
Mlt
Speed 6
5
Mlt
Speed 5
4
Mlt
Speed 4
3
Mlt
Speed 3
2
Mlt
Speed 2
1
Mlt
Speed 1
0
Mlt
Speed 0
.
.
.
.
MltSpd sel 0 src
NULL
MltSpd sel 1 src
NULL
Mlt spd sel mon
MltSpd sel 2 src
NULL
Mlt Spd 0 src
Mlt spd 0
Mlt spd 0
0 rpm
Mlt Spd out
Mlt spd 7
0 rpm
Mlt spd 6
0 rpm
Mlt spd 5
0 rpm
Mlt spd 4
0 rpm
Mlt spd 3
0 rpm
Mlt spd 2
0 rpm
Mlt spd 1 mon
Mlt spd 0 mon
Mlt Spd 1 src
Mlt spd 1
Mlt spd 1
0 rpm
Encoding
Figure D08: Multi speed block