Getinge Maquet FLOW-i 4.2 User Manual

12.3 Cleaning/disinfection procedures
- a summary
A summary of the procedures for cleaning,
disinfection and steam autoclaving is given
here. Details for each step are given in the
following sections.
Cleaning when bacterial/viral filter is used
Dismantle
Wipe off/discard
Assemble
System checkout
If a SERVO DuoGuard filter (or a filter with
equal performance) is used, disinfection or
steam autoclaving of the patient cassette,
volume reflector and associated parts is
usually not necessary.
A complete cleaning procedure should still be
performed at regular intervals according to
hospital routines, or after treating a known
carrier of pulmonary contagious agents.
Disinfection/steam autoclaving when no
bacterial/viral filter is used
Dismantle
Wipe off/discard
Rinse
DryDisinfectant
Rinse
Washer-
disinfector
Dry
Assemble
System checkout
D2D1
Steam
autoclave
There are two disinfection procedures for the
patient cassette, volume reflector and
associated parts: D1 and D2. In D1
(recommended), a Washer-Disinfector
(ISO-15883-1) is used, and in D2 only a
disinfectant is used.
Use only validated processes when steam
autoclaving the patient cassette, volume
reflector and associated parts. See further
instructions in section 11.8.
CAUTION: Steam autoclaving will reduce
the lifetime of the components.
FLOW-i 4.2, User's Manual
237
| Routine cleaning and maintenance |
12 |

Getinge Maquet FLOW-i 4.2 Specifications

General

Brand	Getinge
Model	Maquet FLOW-i 4.2
Category	Medical Equipment
Language	English