m908 User Manual, Rev. G
Illustration 68: Input Channel Setup Screen..............77
Illustration 69: Speaker Channel Setup Screen..........78
Illustration 70: Channel Routing Conflict Dialog......78
Illustration 71: Setup Input Screen............................79
Illustration 72: Input Channel Setup Screen..............79
Illustration 73: Setup Dim Screen.............................81
Illustration 74: Setup Speaker CR Screen..................82
Illustration 75: Speaker Channel Setup.....................83
Illustration 76: Channel Routing Conflict Dialog......84
Illustration 77: DAC 1 Output Circuit.......................85
Illustration 78: DAC 1: 1-2 Output Conflict..............86
Illustration 79: DAC 1: 3-8 Output Conflict..............87
Illustration 80: Bass Management Setup...................88
Illustration 81: Setup SOLO/MUTE Initial Screen....89
Illustration 82: Setup Solo/Mute................................89
Illustration 83: Speaker EQ Parameter Screen...........90
The Room Correction EQ screen displays up to 6
parametric equalizer bands depending on the speaker
"type". Sub channels have 6 bands of EQ while all
other speakers have 3 bands.. Each band contains the
following parameters:.................................................90
Illustration 84: Setup Monitor Screen........................91
Illustration 85: Setup Mono Screen...........................94
Illustration 86: Setup L-R Screen..............................95
Illustration 87: Setup Cue Outs Screen......................96
Illustration 88: Setup Cue Routing Screen................96
Illustration 89: Setup Mute Screen............................98
Illustration 90: Setup ABC User Switch Screen........98
Illustration 91: Meter Output Setup Screen.............100
[Replace Existing Route? dialog]**.........................101
Illustration 92: Setup Talkback Screen....................101
Illustration 93: Setup Talkback Switch Assign Screen
.................................................................................102
Illustration 94: Setup SPL Meter Screen.................103
Illustration 95: Setup System Screen.......................104
Illustration 96: GPIO Jumper Locations..................108
Illustration 97: GPIO Schematic Diagram...............109
Illustration 98: Setup System Screen.......................109
Illustration 99: ADC Stereo Input Routing..............112
Illustration 100: ADC Input Conflict.......................112
Illustration 101: ADC Jumper Locations.................113
Illustration 102: Dante Option Module....................113
Illustration 103: Digilink Option Module................114
Illustration 104: 32 Channel Digilink Connections..115
Illustration 105: 16 Channel Digilink Connections..116
Illustration 106: RIAA Phono Module Jumper
Locations..................................................................118
Illustration 107: USB Audio Control Panel Status...122
Illustration 108: USB Audio Control Panel Buffer
Settings.....................................................................122
Illustration 109: USB Audio Control Panel Format.123
Illustration 110: USB Audio Control Panel Info......123
Illustration 111: Update System Firmware Dialog...124
Illustration 112: ACU Firmware Updating Message125
Illustration 113: Update RCU Firmware Dialog......125
Illustration 114: ACU Firmware Update Complete. 126
Illustration 115: RCU Cable Termination................129
Illustration 116: Remote Talkback Switch Wiring...130
Illustration 117: Remote Talkback Switch with LED
Tally.........................................................................130
Illustration 118: Talkback Out Unbalanced Wiring. 130
Page 133 of 135 Table Of Contents
To Next Page
Loading...
