m908 User Manual, Rev. G
This screen contains the following list of setup parameters that can be highlighted by turning
the VOLUME encoder knob. The available parameters are:
• offset Sets the amount of gain appplied upon subtracting the Right from Left channel.
This parameter can be adjusted from 0 to +6dB in 0.5dB steps. Use it to match the
perceived loudness from stereo to L-R.
• output Sets the output path for the L-R signal. Options are<to L/R, to C>
◦ to L/R sends the L-R signal to the Left and Right speaker equally.
◦ to C Sends the L-R signal to the Center speaker only. Left and Right speakers are
muted.
• mode Sets which monitor paths are affected by the L-R processor. Options are <speakers
+ headphones, speakers only, headphones only>
Push the SETUP switch to save and exit Setup Mode.
6.3.14 CUE setup
Push the SETUP then push the MON>CUE switch to enter the Setup Cue Outs screen. NOTE:
the current state of mon>cue will be unchanged by this action. Once in Cue Outs setup, the
MON>CUE switch returns to normal operation.
Page 95 of 135 Table Of Contents
To Next Page
Loading...
