m908 User Manual, Rev. G
• speaker reference level Adjusts the speaker reference level. Range is <0 to 100>
in 0.5dB steps. This parameter represents the reference level that is displayed (when
speaker level display mode = reference level) at the current volume setting. Available
range is the current volume setting +/- 100 in 0.5 steps. This parameter is the same for all
speaker outputs.
The following is an example of how the reference level may be configured for an
82dBSPL reference listening level:
◦ Play and monitor a nominal level noise source.
◦ Adjust the speaker level until the SPL measurement at the listening position equals
82dBSPL.
◦ Enter SETUP then push-hold the VOLUME encoder to enter the Setup Monitor
screen and navigate to speaker reference level parameter. Adjust it to 82.
◦ Set speaker level disp mode to <reference>
• speaker limit level Sets the maximum volume level that the Control Room speaker
can be set to.
• speaker preset level Sets the level that the speaker system will go when on push-hold
of the VOLUME encoder while in the Home screen.
• speaker power-up level Sets the volume level that the speaker system will go to
after power up.
• lfe input lpf freq Enables and sets the LFE channel low pass filter cutoff frequency.
Options are <bypass, 80-120hZ>
• lfe input gain Sets the LFE channel gain. Options are <0db, +10dB>
• bass management Enables or disables bass management. Options are: <bypassed,
enabled>
• room equalization Enables or disables all room correction equalizers. Options are:
<bypassed, enabled>
• headphone source Selects the stereo signal source for the headphone amplifier. Options
are <left/right, downmix, cue 1-8>.
◦ left/right: the headphone source is the same signal feeding Control Room left and
right with mono,l-r and mute behavior as configured in setup menus. If downmix is
active in the CR Outputs the headphones will receive the downmixed signal.
◦ downmix: Inserts the stereo output phones/cue downmixer for monitoring in stereo
when the CR Outputs are monitoring in surround.
◦ cue 1-8: Routes one of the Cue outputs to the headphone amplifier. When a cue is
being monitored on headphones the Cue output routing is still active.
• headphone gain Adjusts the gain of the headphone system to match the sensitivity
of your headphones. Adjustment range is -20dB to +20dB in 0.5dB steps.
Page 92 of 135 Table Of Contents
To Next Page
Loading...
