GRAPHTEC FC9000-140 - Page 130

5-16
Adjusting for the registration mark scan position
Sensor to scan the registration mark is positioned away from the tip of the tool (pen tip). Therefore, it is
QHFHVVDU\WRDGMXVWWKHFRRUGLQDWHYDOXHVRIWKHVFDQQHGUHJLVWUDWLRQPDUNVRLWZLOOPDWFKZLWKWKHFXWWLQJ
position.
If the registration mark is already marked on the media, scan that registration mark, plot another registration
PDUNLQWKHVDPHSRVLWLRQDQGPHDVXUHWKHGLIIHUHQFHEHWZHHQWKHP7KLVGLIIHUHQFHLVHQWHUHGDVDDGMXVWPHQW
value.
,IWKHUHLVQRUHJLVWUDWLRQPDUNRQWKHPHGLDSORWDUHJLVWUDWLRQPDUNÀUVWVFDQWKDWUHJLVWUDWLRQPDUNSORW
DQRWKHUUHJLVWUDWLRQPDUNDQGPHDVXUHWKHGLIIHUHQFHRIWKHP7KLVGLIIHUHQFHLVHQWHUHGDVDDGMXVWPHQWYDOXH
:KHQXVLQJPHGLDDQGWRROVIRUDFWXDOXVHWKHDGMXVWPHQWDFFXUDF\ZLOOEHKLJKHU
Reference
There is a restriction on the shape (style) of the registration marks that can be scanned. See "Shape (Pattern) of Registration Mark".
Adjust after plotting the adjustment registration mark
This section describes the steps to plot the registration mark.
5HJLVWUDWLRQPDUNLVWREHSORWWHGLIWKHUHLVQRUHJLVWUDWLRQPDUNRQWKHPHGLDWRDGMXVWWKHUHJLVWUDWLRQPDUN
VFDQSRVLWLRQ6XEVHTXHQWO\LWFRQWLQXHVWR$GMXVWLQJWKHUHJLVWUDWLRQPDUNSRVLWLRQ
Reference
Proceed to "Setting the Position Using ARMS" without plotting the registration mark if the registration mark is already drawn on the
media.
Operation
Reference
See "Loading Media (Paper or Marking Film)"
for loading white media.
1
Load white media.
Reference
See "Attaching a Tool" for setting the water-
EDVHGÀEHUSHQ,IWKHZDWHUEDVHGÀEHUWLSSHQ
has been scratched, then it may not scanned.
2
6HWWKHZDWHUEDVHGÀEHUSHQEODFNRQWKHWRROKROGHU
(Backward).
3
Press the [PAUSE/MENU] key.
MENU screen is displayed.