5-17
4
Press the [2] key (ARMS).
ARMS SETTING screen (1/3) is displayed.
5
Press the POSITION ( ) key.
ARMS SETTING screen (2/3) is displayed.
Reference
It will return to ARMS SETTING screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
6
Press the [1] key (SENSOR OFFSET ADJ.).
SENSOR OFFSET ADJ. screen is displayed.
7
Press the [1] key (TEST PATTERN).
Following message is displayed.
8
Press the POSITION (
) keys and move the tool
carriage to the position to plot the registration mark (position
nothing is printed).
Reference
It will return to SENSOR OFFSET ADJ. screen
without plotting by pressing the [ESC] key
(CANCEL).
9
Press the [ENTER] key.
$DGMXVWPHQWUHJLVWUDWLRQPDUNLVFUHDWHGDQGWKHQLWZLOOUHWXUQWR
SENSOR OFFSET ADJ. screen.
To Next Page
Loading...
