GRAPHTEC FC9000-140 - Page 36

2-10
When using FC9000-100/140/160
Supplement

The media must always be positioned over
the media sensor.

See "Aligning the Push Rollers" for the
position of the push rollers.

See "Aligning the Push Rollers" for information
about push roller hold-down force.
Use the 3 or 4 push rollers to push down the sides and center
of the media. Use the grit roller position guide and make sure
the push rollers are on top of the grit rollers.
<RXFDQDGMXVWWKHSXVKUROOHUVKROGGRZQIRUFH
Grit roller position guide
Push roller
Media sensor
Grit roller
Push roller
(The center push roller is not on top of the grit roller.) (The center push roller is near the edge.)
(The center push roller is on top of the grit roller.)(The center push roller is on top of the grit roller.)
When feeding long media (2 meters or more)
Position the push rollers at least 15 mm inside the edges of
the media.
Push roller
Media
15 mm 15 mm