GSE Scale Systems - 147
Chapter 16 Macro Programming Operations Technical Reference Manual
Macro
Command
x%f
n%F
n%g
?%g
%G
(message)
%I
n%J
%k
n%k
*%k
n%K
Description
Check to see IF a Presetable Parameter is
preset.
"IF" setpoint "n" is deactivated, process
following commands. For further
information, refer to the explanation of IF
commands.
Check IF a specific sample error has
occured.
Displays current state of sample error
flags.
GET operator input. (Wait until operator
makes an entry and then presses
[ENTER].
Perform Weight Conversion Process. ie
calculate currently applied weight, update
numeric display, and setpoint and analog
outputs. If an optional message precedes
the %I command, then that message is
displayed during the process. Otherwise
the dot matrix portion of the display will
show the standard information for the
current mode.
JUMP to TAG. This command is used in
conjunction with the %T (TAG) command
in order to allow looping within a macro.
Put current filter selection in entry buffer.
Set filter selection (n = 0 thru 7) or (15
thru 17 auto-filter)
Resets the filter selection to default as
defined in parameter P116.
Sets up a timer to invoke macro 15 in "n"
seconds.
Setpoint
Related
X
X
Operator
Input/
Output
X
X
Branch-
ing
X
X
X
X
X
Math
Com-
mands
X
X
Com-
muni-
cations
SECTION - 16.8
To Next Page
Loading...