Model 574 Programmable Counting System (PCS)
148 - GSE Scale Systems
Macro
Command
%L
n%L
n%M
%N
n%O
(message)
%P
n%Q
Description
Display the “number selection” of the
currently selected language.
Change language selection on the fly. The
variable “n” can be selections 0 - 12.
IF the current mode is mode "n", then
process the following macro commands.
For further information, refer to the
explanation of IF commands.
NOT IF: This command marks the spot
where macro execution resumes if the
previous IF statement result was false.
For further information, refer to the
explanation of IF commands.
IF setpoint "n" is activated, process the
following commands. For further
information, refer to the explanation of IF
commands.
PAUSE for programmable time (set using
the %@ command), while performing the
weight conversion process. Default delay
time is one second. If the optional
message precedes the %P command, then
that message is displayed during the
PAUSE. Otherwise the standard
information for the current mode is
displayed.
Sends the "n"th custom transmit, as
programmed in the setup mode. The
value for "n" can be 1, 2, 3, or 4.
Setpoint
Related
X
Operator
Input/
Output
X
Branch-
ing
X
X
X
Math
Com-
mands
X
Com-
muni-
cations
X
To Next Page
Loading...