GSE 574 - Page 168

GSE Scale Systems - 149
Chapter 16 Macro Programming Operations Technical Reference Manual
Macro
Command
%r
0%r
1%r
n%R
%S
n%T
n%U
n%V
(message)
%W
%X
Description
IF RTS Asserted
Deassert RTS
Assert RTS
IF register "n", is not zero, process the
following commands. "n" can be 1, 2, 3,
or 4 for parameters 91 - 94). For further
information, refer to the explanation of IF
commands.
SOUNDS the beeper for 1/2 second.
TAG current position for later JUMP (n
%J). Refer to the section describing
jumping for further information.
If TX buffer is empty (COM or Print)
IF setpoint input "n" is active, process the
following macro commands. For further
information, refer to the explanation of IF
commands.
WAIT for operator to press any key. If
the optional message precedes the %W
command, then the message is displayed
while awaiting the operator to press a key.
Request current display from remote.
(Diagnostic command)
Setpoint
Related
Operator
Input/
Output
X
X
Branch-
ing
X
X
X
X
X
Math
Com-
mands
Com-
muni-
cations
X
X
X
X
X
SECTION - 16.8