GSE Scale Systems - 35
Chapter 4 Parameter Setup (Advanced) Technical Reference Manual
PARAMETER # SELECTION DESCRIPTION
SECTION - 4.6
PRESET
CHARACTERS
P412.00 PrSET * Disbl Preset-able parameters can be flagged
or not if a value is directly entered into
P412.01 PrSET Enbld them. If these parameters are printed
2 Tare or transmitted a “P” is placed in front
3 GrTOT of the parameter name. If enabled,
4 GrT+C any recalled data to these registers will
5 GrT-C also indicate that the data in the
6 NtTOT register has been placed there by other
7 NtT-C means. The letter “P” will appear in
8 NtT-C the display in front of the parameter’s
31 QtTOT name if this feature is enabled. It will
32 QtT+C also print out with the letter “P”
33 QtT-C prepended in front of the parameter
34 APW name. If any of these parameters are
35 APW*K renamed and preset is enabled, the
first character in the rename area must
be the flagging character. Include the
first character in the rename as the
prepended flagging character.
VARIABLE DECIMAL
PLACES
P480.00 VarDP =0 Sets Var#0 Decimal at x.
P480.01 =1 Sets Var#0 Decimal at x.x
P480.02 =2 Sets Var#0 Decimal at x.xx
P480.03 =3 Sets Var#0 Decimal at x.xxx
P480.04 =4 Sets Var#0 Decimal at x.xxxx
P480.05 =5 Sets Var#0 Decimal at x.xxxxx
P480.06 * =Auto Sets Var#0 Decimal at automatic
P481 through P489 * Sets the significant digits
following the decimal point
for Variables #1 thru #9, the
same as parameter P480.
To Next Page
Loading...