GSE 574 - Page 72

GSE Scale Systems - 53
Chapter 4 Parameter Setup (Advanced) Technical Reference Manual
PARAMETER # SELECTION DESCRIPTION
SECTION - 4.6
P5150.º Par85 Var#5
P5150.º Par86 Var#6
P5150.º Par87 Var#7
P5150.º Par88 Var#8
P5150.º Par89 Var#9
P5150.º Par91 Reg#1
P5150.º Par92 Reg#2
P5150.º Par93 Reg#3
P5150.º Par94 Reg#4
The above listing of parameters ranging from P5100.0 thru P5150.º are the detailed listings only for Setpoint 1.
Parameters P5200 thru P8200 are used for Setpoints 2 thru 32. The remaining setpoints have not been listed in
detail, however you can substitute the Parameter number of the desired setpoint number into the above listing.
(Setpoint inputs are not valid in the M574, contact GSE for more information.)
MACRO SETUP
(ACTIVATE)
P5160.X Actv Activate Macro
P5160.0 Macro #0
P5160.1 Macro #1
through
P5160.-- Macro #15
P5160.-- None!
MACRO SETUP
(DE-ACTIVATE)
P5161.X Actv De-Activate Macro
P5161.0 Macro #0
P5161.1 Macro #1
through
P5161.-- Macro #15
P5161-- None!
INFORMATION AND DIAGNOSTIC PARAMETERS
The following parameters P60000 to P65010 are part of a separate group that may be reached from any mode
by entry of one of their parameter numbers. Some may require installation of Option modifications to the
System.
P60000. E2Ins * 2048 Displays the amount of
E
2
memory.