Windsor 500 User Manual - Issue C
Isolate Concentrator
The isolate concentrator operation enables a concentrator to be isolated in case of a fault.
1=Circuit
2=Concentrator
1. Select 2 from the ’Isolate’ menu.
Concentrator
Number
2. Enter the concentrator number which requires isolation
Isol Conc X
Off
3. Press 1 to isolate or 0 to remove isolation.
4. Press ’Quit’ to return to the ’Isolate’ menu.
1=Circuit
2=Concentrator
Note : The circuit isolate will only be removed if the fault condition has cleared. To re-
enable repeat the above procedure.
2
Quit
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
