Windsor 500 User Manual - Issue C
Changing User Authority
The user authority can be allocated and changed by a ’Manager’ user. To allocate or change the authority of
a user, proceed as follows:
2=Set 4=Test
5=Eng 6=Text.....
1. Log on to a Keypad using a PIN code with ’Manager’ authority.
2. Press ’Enter’ to move the display to page 2 of the user options.
1=Chime 2=KPOff
3=Event Log
3. Press ▼ to view the remaining page 2 user options.
4=User
5=Time 6=Keys
4. Select 4 from the user options menu.
User Number--
5. The display will prompt for the user number whose authority has to be allocated or
changed. Enter a two-digit user number (03-50).
User-03
W. Smith
6. The display will show the selected user number and any user name programmed
against the user number.
User 03
Off
7. Approximately 4 seconds later, the display will show the current authority allocated to
the selected user.
Note: When allocating an authority to a new user, the default authority is shown, e.g.
“Off”.
0=Off 1=Manager
2=Ordinary........
8. Select an authority level for the selected user. A list of authority levels is shown on
the display by pressing the 'Help' button. To view the complete selection, use the ▼
button. Alternatively, enter a number corresponding to the authority level from the list
below.
There are 12 authority menu options on 2 menu pages.
0=Off 1=Cleaner
1=Manager 2=Unset
2=Ordinary 3=Access
3=Set/Uns
↵=Next Page
4=Set
5=Event Log
6=Bank Rst
7=Reset
8=Duress
9=ATM
↵=Next Page
2
▼
4
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
