Windsor 500 User Manual - Issue C
Unsetting Methods
General
Unsetting of an area or system can only be requested by a user with authority to unset the particular area (or
system) and from a Keypad or Keypoint programmed to permit unsetting of the area (or system)
Unsetting can be initiated by a user request on a Keypad or Keypoint, by opening an entry circuit, by turning a
Keyswitch to the 'Off ' position, or automatically if the event programmer is configured for ‘Auto Unsetting'.
Entry Route Unsetting
If an area (or system) incorporates an entry route in the unsetting procedure, opening a 'final' entry door to
the area will automatically start a pre-programmed entry timer and cause the area sounder to emit a
continuous entry tone. The user must proceed directly to the area (or system) Keypad/Keypoint or Keyswitch
via a pre-determined entry route and unset the area (or system) as described. If the area (or system) is not
unset before the entry time has expired the sounder(s) will change to an intermittent pulsing tone for a
warning period (an additional 50% of the programmed entry time). This is to warn the user that an alarm
condition will occur if the area (or system) is not unset by the time that the warning period has expired. If the
system (or area) is not unset by the time that the total 'Entry Time' and 'Warning Time' has expired, an alarm
condition will be initiated.
If, on entry, a user deviates from the prescribed entry route into an armed area during the entry time, the
entry time is immediately cancelled and replaced with a fixed pre-warning period of 45 seconds. If the user
enters an armed area during the additional 50% warning period, the warning period is cancelled and an alarm
condition initiated.
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
