GW Instek PSU Series - System:configure:trigger:input:source

REMOTE CONTROL
115
Note
The setting will only be valid after the power has been
cycled.
Syntax
Return Syntax
:SYSTem:CONFigure:CONTrol:RANG
{<NR1>|LOW|HIGH}
:SYSTem:CONFigure:CONTrol:RANGe?
Parameter
LOW | 0
5V [5kΩ]
HIGH| 1
10V [10kΩ]
Return Parameter
<NR1>
Returns the range setting.
Example
SYST:CONF:CONT:RANG LOW
SYST:REB
Set external analog control voltage (or resistance)
range to 0~5V [5kΩ] and reboot the unit to active
the setting.
:SYSTem:CONFigure:TRIGger:INPut:SOURce
Set
Query
Description
Sets or queries what action will be performed on
receiving a trigger.
Syntax
Return Syntax
:SYSTem:CONFigure:TRIGger:INPut:SOURce
{<NR1>|NONE|OUTPut|SETTing|MEMory}
:SYSTem:CONFigure:TRIGger:INPut:SOURce?
Parameter
NONE | 0
No input trigger.
OUTPut | 1
Toggles the output on receiving a
trigger.
SETTing | 2
Sets the voltage/current on receiving
a trigger.
MEMory | 3
Loads a memory setting on receiving
a trigger.
Return Parameter
<NR1>
Returns the input source.