GW Instek PSU Series - Commands:Output:delay:off; Output:Output:delay:on

REMOTE CONTROL
85
Output Commands
:OUTPut:DELay:ON ........................................................... 85
:OUTPut:DELay:OFF ......................................................... 85
:OUTPut:MODE .................................................................. 86
:OUTPut[:STATe][:IMMediate] ......................................... 86
:OUTPut[:STATe]:TRIGgered ........................................... 86
:OUTPut:PROTection:CLEar ............................................ 87
:OUTPut:PROTection:TRIPped ....................................... 87
:OUTPut:DELay:ON
Set
Query
Description
Sets the Delay Time in seconds for turning the
output on. The delay is set to 0.00 by default.
Syntax
Query Syntax
:OUTPut:DELay:ON {<NR2>|MINimum|MAXimum}
:OUTPut:DELay:ON?
Parameter
<NR2>
0.00~99.99 seconds, where 0=no delay.
Return parameter
“0.00”
Returns the delay on time in seconds
until the output is turned on.
:OUTPut:DELay:OFF
Set
Query
Description
Sets the Delay Time in seconds for turning the
output off. The delay is set to 0.00 by default.
Syntax
Return Syntax
:OUTPut:DELay:OFF {<NR2> |MINimum|MAXimum}
:OUTPut:DELay:OFF?
Parameter
<NR2>
0.00~99.99 seconds, where 0=no delay.
Return parameter
“0.00”
Returns the delay off time in seconds
until the output is turned off.