GW Instek PSU Series Programming Manual

REMOTE CONTROL
123
“LEGACY”
Sets the communication protocol to
legacy mode. (Emulate TDK Genesys)
Example
SYST:COMM:SER:LANG?
>SCPI
Indicates that the communication protocol is set to
SCPI.
:SYSTem:COMMunicate:SERial[:RECeive]
:TRANsmit:BAUD
Set
Query
Description
Sets or queries the UART baud rate.
Note
The setting will only be valid after the power has been
cycled.
Syntax
Query Syntax
:SYSTem:COMMunicate:SERial[:RECeive]:TRANsmit
:BAUD <NR1>
:SYSTem:COMMunicate:SERial[:RECeive]:TRANsmit
:BAUD?
Parameter/Return
<NR1>
2400, 4800, 9600, 19200, 38400, 57600,
115200
Example
SYST:COMM:SER:TRAN:BAUD?
>2400
Returns the baud rate settings.
SYST:COMM:SER:TRAN:BAUD 9600
SYST:REB
Set the UART baud rate to 9600bps and reboot the
unit to active the setting.
:SYSTem:COMMunicate:SERial[:RECeive]
:TRANsmit:BITS
Set
Query
Description
Sets or queries the UART number of data bits.
Note
The setting will only be valid after the power has been
cycled.

GW Instek PSU Series Specifications

General

Brand	GW Instek
Model	PSU Series
Category	Power Supply
Language	English