Hakko Electronics Monitouch V7 - Page 71

2-14 1. Operation of V7 Main Menu
5. Starting Data Transfer
Press the [Start] switch. Data transfer is started. During data transfer, the [Start] switch
changes into [Busy] and flashes. When data is transferred, the following message is
displayed.
Press the [OK] switch.
6. Press the [Close] switch. The “Card Menu” screen is displayed again.
CREC Menu
Return
Start
Cancel
Screen Data Font Data
I/F Driver Sys. Program
Data Selection
Display
Display
Display
Card
Card
Card
CREC Menu
Return
Start
Cancel
Screen Data Font Data
I/F Driver Sys. Program
Data Selection
Display
Display
Display
Card
Card
Card
Memory-Card Information
Sys. Program
Version
Font Date
Version
I/F Driver
Version
Screen PLC Type
Screen Comment
:
: -.---
:
: -.--- / -.--- / -.---
: YOKOGAWA FA
: 1.250
: YOKOGAWAFA-M3
:
CREC Menu
Return
Start
Cancel
Screen Data Font Data
I/F Driver Sys. Program
Data Selection
Display
Display
Display
Card
Card
Card
Memory-Card Information
Sys. Program
Version
Font Date
Version
I/F Driver
Version
Screen PLC Type
Screen Comment
:
: -.---
:
: -.--- / -.--- / -.---
: YOKOGAWA FA
: 1.250
: YOKOGAWAFA-M3
:
Memory-Card Information
Sys. Program
Version
Font Date
Version
I/F Driver
Version
Screen PLC Type
Screen Comment
:
: -.---
:
: -.--- / -.--- / -.---
: YOKOGAWA FA
: 1.250
: YOKOGAWAFA-M3
:
Close
Close
Close
Work normally finished.
OK