EB+ Gen3Installation guide
472013 Innovative Vehicle Solutions
Piping information
› Actual pipe sizes need to be optimized for individual trailer response time requirements
› All pipe and rubber hose to comply to recognized international standards
› Nylon pipe to DIN 73378, rubber hose to SAE 1402
› The referenced sizes are defined as guide lines only
› For optimum performance all pipe lengths should be as short as possible
Pipe ttings
Avoid elbows as much as possible. If essential, use
swept type elbow.
Inside diameter of fitting should be the same as the
inside pipe diameter it is serving.
On metric (parallel thread) pipe fitting a backing
washer and ‘O’ ring should be used.
The use of tape (PTFE) must not be used.
Note:
No pipe sealant or tape (PTFE) must be used during the
installation of EB+ Gen3. No warranty claims will be
accepted on pipe sealant or tape induced faults.
To Next Page
Loading...
