EB+ Gen3 Installation guide
42 Innovative Vehicle Solutions 2013
Sensor connection
Sensor extension cable socket must be pushed fully
into sensor cable plug till they clip into place to prevent
falling out with axle vibration.
Haldex recommend that all electrical components
are greased prior to assembly using the appropriate
electrical grease.
Where possible use a clip and bracket to secure sensor
cable connection.
The female connector of the sensor cable should
always be horizontal or pointing downward to reduce
the possibility of water ingress.
Alternatively: sensor cable connection to be positioned
on axle or between axle ‘U’ bolts and supported with
cable ties with 50 mm of each end.
Extension cable plug Sensor cable socket
Clip to ‘click’
Sensor cable Extension cable
Dirt shield
Connection
assembled into clip
and bracket
Dirt shield
fixing bolts
Axle
‘U’ bolts
Cable tie
Cable tie
Axle
Connection
Hub and drum/
disk assembly
To Next Page
Loading...
