Harmonic Ellipse 3000 - Test Tone

Chapter 6 Audio Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved. 141 Ellipse 3000 Release 3.0, Rev. B
Audio General Menu
Front Panel
To set the Source parameter on the front panel:
❖ Navigate Root > Configuration > Audio > [Audio Channel#] > General > Source.
Web Manager
To set the Audio Source parameter in the Web Manager Audio General menu:
❖ Select Audio > Aud#.
6.2.3 Test Tone
The Test Tone parameter sets the audio-pattern-source-self-test mode of operation. The Audio
test simulates 1 kHz test tone input.
The available options are:
■ Off – Deactivates the audio test
■ On – Activates the audio test
The Test default is Off.
Front Panel
To set the Test parameter on the front panel:
❖ Navigate Root > Configuration > Audio > [Audio Channel#] > General > Test Tone.
Web Manager
To set the Test Tone parameter in the Web Manager Audio General menu:
❖ Select Audio > Aud#.
Source 1-2
1 ‚ Analog
2 ƒ Digital
3 ‚ Embedded
4 ‚ NA
Test Tone
1-3
1 ƒ Off
2 ‚ On