Harmonic Ellipse 3000 - MPEG-2 Analog Transport Stream and VBI Configuration

Chapter 2 Initial Configuration and Basic Opera-
tion
© 2013 Harmonic Inc. Harmonic All rights reserved. 33 Ellipse 3000 Release 3.0, Rev. B
Ellipse Set-Up Procedures
2.2.3 MPEG-2 Analog Transport Stream and VBI Configuration
Configuring the Ellipse encoder to receive and process an MPEG-2 analog standard definition
stream consists of the following main actions:
■ Configuring video input parameters for the analog composite video received (refer to
2.2.3.1 MPEG-2 SD Video Input Configuration Set-up Procedure).
■ Configuring video parameters for MPEG-2 standard definition processing (refer to
2.2.3.2 MPEG-2 Analog Video Configuration Set-up Procedure).
■ Configuring new service parameters (refer to 2.2.3.3 MPEG-2 Analog New Service
Configuration Set-up Procedure).
2.2.3.1 MPEG-2 SD Video Input Configuration Set-up Procedure
This procedure uses the front panel interface. It can be equally performed using the web manager
interface. Refer to 5.1 Input Sub-Menu/Box of this manual for detailed information about the
options provided on each front panel and the respective web manager interface.
To define an SD PAL analog video program received at CV input with the following parameters:
■ PAL Video standard
■ Auto 4:3 aspect ratio
■ VBI PID at 2000
■ Teletext on VBI line 11/Odd
■ Teletext Initial page at #100/English subtitling page0: #200/English
■ Subtitling page1: #201/French
■ Subtitling page2: #202/German
■ Subtitling page3: #203/Dutch
■ Additional information page: #300/English
■ Program schedule page #400/English
1. Navigate Root>Configuration>Video>Video>Input>Input Format.
2. Select PAL and press <Enter> on the front panel to set the video standard for the program.
3. Press F1 on the front panel to save.
4. Navigate Root>Configuration>Video>Video>Input>Ancillary Data.
Input Format
1 ƒ Auto Detect
2 ‚ PAL
3 ‚ NTSC
4 ‚ PAL-M
5 ‚ PAL-CN