Chapter 10 Unit Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved. 288 Ellipse 3000 Release 3.0, Rev. B
SNMP Traps Sub-Menu
10.4.3.1 Select Entry to Drop
The Select Entry To Drop parameter displays a select value screen with the complete Traps
Destinations list, allowing the user to select the entry-to-drop.
To set the Select Entry To Drop parameter on the front panel:
❖ Navigate Root > Configuration > Unit > SNMP Traps > Drop Entry > Select Entry To Drop.
The Drop Entry option allows deleting the selected entry from the Traps Destinations list. The
entry-to-drop is selected by the Select Entry To drop parameter (see the previous section). This
option executes the Drop Entry command, not leading to a new screen.
10.4.4 Adding and Dropping Entries (Web Manager)
The Web Manager allows managing the trap-destination hosts’ list with an ease of point-and-
click.
To create, edit and drop SNMP Traps using the Web Manager:
❖ Select
Unit > SNMP Traps > [trap entry].
The following sections detail the adding and dropping entries from the list.
Select Entry To Drop
ƒ Remote_Control
‚ New Host
To Next Page
Loading...
