Chapter 10 Unit Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved. 282 Ellipse 3000 Release 3.0, Rev. B
SNMP Traps Sub-Menu
10.4 SNMP Traps Sub-Menu
The SNMP Traps sub-menu allows defining a trap-host for the encoder’s trap messages. The
menu allows viewing the Traps Destinations list, which defines the trap hosts of the unit. The
menu commands also allow adding or deleting entries from the Traps Destinations list.
NOTE: Trap messages are sent by the device without manager intervention whenever a notification event
occurs. Currently, the Ellipse support alarms notifications and alarm cancellations (known as alarmOn and
alarmOff). For more information about SNMP traps and Ellipse SNMP abilities, refer to the Ellipse MIB User
Guideline documentation.
NOTE: At least one IP destination must be defined to enable the Drop Entry option.
Front Panel
To access the SNMP Traps sub-menu on the front panel:
❖ Navigate Root > Configuration > Unit > SNMP Traps.
Web Manager
To access the SNMP Traps sub-menu in the Web Manager:
❖ Select Unit > SNMP Traps.
The following sections detail the menu options and parameters.
SNMP Traps
1 Traps Destinations List
2 Add Entry
3 Drop Entry
To Next Page
Loading...
