Harmonic Ellipse 3000 - Page 36

Chapter 2 Initial Configuration and Basic Opera-
tion
© 2013 Harmonic Inc. Harmonic All rights reserved. 36 Ellipse 3000 Release 3.0, Rev. B
Ellipse Set-Up Procedures
4. Press F1 on the front panel to save the parameters (refer to Section 2.1.1.3. for configuration
save instructions).
5. Navigate Root > Configuration > Video > Video > Encoding > PID.
6. Configure PID to 450 (use the alphanumeric touch-pad on the front panel to enter the value).
7. Press <Enter> on the front panel to confirm and return to the Encoding menu.
8. Configure Activation to Enabled to enable the video channel.
9. Press <Enter> to return to the Encoding screen.
10. Scroll the Encoding screen and make sure that all other parameters are at the required
default values.
11. Press F1 on the front panel to save the parameters.
2.2.3.3 MPEG-2 Analog New Service Configuration Set-up Procedure
This procedure uses the front panel interface. It can be equally performed using the web manager
interface. Refer to section 4.2 Services Sub-Menu/Tab of this manual for detailed information
about the options provided on each front panel and the respective web manager interface.
To create a new service called bbc1:
1. Navigate Root > Configuration > Transport Stream > Services > Add New.
2. Use the Service Name parameter to set bbc1 as the name of the new service (use the
alphanumeric touch-pad to enter the service name).
3. Press <Enter> to confirm and return to the Add New menu.
4. Use the Add parameter to add the new service to the transport stream.
Encoding
1 Activation
Disabled
2 PID
0200
3 Codec Profile
MPEG-2 4:2:0 8-bit
4 Latency Control
Standard
5 Resolution
644 x 576
Add New
1 Service Name
First_service
2 Add