Loading System Software using DHCP 5-5
920550-5020 Rev 14 HN4000 Hardware Installation Guide
Thefollowingisaloginexample:
Login: admin<Enter>
Password: <Enter>
*********************************************************************
* HATTERAS NETWORKS COMMAND LINE INTERFACE (CLI) *
* *
* Copyright (C) 2001-2008 Hatteras Networks. All rights reserved. *
* *
* W A R N I N G *
* *
* This computer program is protected by copyright and *
* international law. Unauthorized use or distribution *
* may result in severe civil and criminal penalties, *
* and will be prosecuted to the maximum extent possible *
* under law. *
*********************************************************************
Logged into MASTER Switch (Switch 1)
HN4000-1M#
Whenyouloginsuccessfully,theCLI’sinformationbannerappears,followedbythe
CLIprompt.
Step 2. Usetheshowip1commandtodisplaytheIPattributesofthemanagementport:
HN4000-1M# show ip 1
Ethernet port 1 IP parameters:
Keyword Description Value
---------------- ---------------------------------------- --------------------
admin IP administrative state (config/actual) disable/disable
oper IP operational state disabled
dhcp DHCP state disable
ipAddress Configured IP address 0.0.0.0
ipNetMask Configured IP network mask 0.0.0.0
gateway Configured Gateway IP address 0.0.0.0
metric Interface metric (config/actual) 100/100
ipAcl IP Access Control List (config/actual) none/none
override Config override method none
actIpAddress Actual IP address 0.0.0.0
actIpNetMask Actual IP network mask 0.0.0.0
actGateway Actual Gateway (* = current default) 0.0.0.0
Ethernet port 1 alternate IP parameters:
Keyword Description Value
---------------- ---------------------------------------- --------------------
admin IP administrative state disable
oper IP operational state disabled
ipAddress IP address of this interface 0.0.0.0
ipNetMask IP network mask 0.0.0.0
HN4000-1M
To Next Page
Loading...
General