To Next Page

To Previous Page

5-6 Loading System Software using DHCP

HN4000 Hardware Installation Guide 920550-5020 Rev 14

Step 3. Usetheconfigcommandtoenabletheport’s“admin”and“dhcp”attributes:

HN4000-1M# config ip 1 admin enable dhcp enable

OK: Action completed.

HN4000-1M#

Afterexecutingthiscommand,theDHCPserverwillconnecttotheHN4000and

downloadIPandgatewayinformation.Thisoperationtakesapproximately

10secondstocomplete.

Step 4. Usetheshowip1commandtoverifythattheHN4000’sIPattributeshavebeenset.

Forexample:

HN4000-1M# show ip 1

Ethernet port 1 IP parameters:

Keyword Description Value

---------------- ---------------------------------------- --------------------

admin IP administrative state (config/actual) enable/enable

oper IP operational state active

dhcp DHCP state enable

ipAddress Configured IP address 0.0.0.0

ipNetMask Configured IP network mask 0.0.0.0

gateway Configured Gateway IP address 0.0.0.0

metric Interface metric (config/actual) 100/100

ipAcl IP Access Control List (config/actual) none/none

override Config override method dhcp

actIpAddress Actual IP address 192.168.1.87

actIpNetMask Actual IP network mask 255.255.255.0

actGateway Actual Gateway (* = current default) *192.168.1.254

Ethernet port 1 alternate IP parameters:

Keyword Description Value

---------------- ---------------------------------------- --------------------

admin IP administrative state disable

oper IP operational state disabled

ipAddress IP address of this interface 0.0.0.0

ipNetMask IP network mask 0.0.0.0

HN4000-1M#

Hatteras HN4000 User Manual

Questions and Answers: