Hioki 8807-01 - Setting the Print Mode

83
_____________________________________________________________________
5.3 Setting Items
______________________________________________________________
Flashing cursor
Wave
Prints measurement data as a waveform.
Logging
Print measurement data numerically.
Set the spacing of the printed words.
NOTE
When "Logging" is selected, if the print interval is set longer
than the record length, only the first point will print.
When "Logging" is selected, the maximum and minimum values
are printed. (Refer to Appendix 2.)
Even if the print interval is set at 1 to 40 points, the print
interval used with real time printing is automatically set to 80
points.
If you want to print with a print interval of 1 to 40 points, press
the
PRINT
button after measurement has stopped.
5.3.6 Setting the Print Mode
This mode is available when the 8992
PRINTER UNIT
is
connected. Select whether to print measurement data as
waveform or numeric values.
Procedure
Status Screen
1. Press the
SET
button to display the Status Screen.
2. Move the flashing cursor to
Print Mode
and
select
Wave
or
Logging
using the buttons.
3. Press the buttons to set the print interval (1 division =
80 points) when "Logging" is selected.