Hioki 8807-01 - Text Entry Procedure

220
_____________________________________________________________________
11.3 Comment Screen (Printer)
______________________________________________________________
Flashing cursor
Flashing cursor
Comment
Entry Window
11.3.3 Text Entry Procedure
Comments and other text items are entered by the following
procedure. Scaling units for the Scaling Screen are entered
by the same procedure.
Procedure
Comment Screen
1. Press the
SYSTEM
button to display the Comment Screen.
2. Move the flashing cursor to the Title, Analog, or Logic
items and select
Comment
or
Set&Com
using the
buttons.
3. Move the flashing cursor to the position as shown in the
figure below and use the
buttons to display the
Comment Entry Screen.