217
_____________________________________________________________________
11.3 Comment Screen (Printer)
______________________________________________________________
Flashing cursor
OFF
The setting items of the input channel and
comment are not printed.
Setting
The setting items of the input channel are printed.
Comment
The comment of the input channel is printed.
Set&Com
The setting items and comment of the input
channel are printed.
11.3.2 Analog and Logic Comment Entry
A comment consisting of up to 24 characters can be printed
on the recording paper for each channel.
Select "Set&Com" (Settings and Comments) to print
settings (voltage axis range, magnification/compression ratio
along the voltage axis, zero position, low-pass filter, and
waveform display range) together with comments.
Procedure
Comment Screen
1. Press the
SYSTEM
button to display the Comment Screen.
2. Move the flashing cursor to the position as shown in the
figure below and use the
buttons to make a setting.
To Next Page
Loading...
