Hioki 8807-01 - Setting the Print Mode

104
_____________________________________________________________________
6.3 Setting Items
______________________________________________________________
Flashing cursor
Wave
Prints measurement data as a waveform.
Logging
Print measurement data numerically. Set the
spacing of the printed words.
NOTE
When "Logging" is selected, if the print interval is set longer
than the record length, only the first point will print.
When "Logging" is selected, the maximum and minimum values
are printed (excluding 100 ms/DIV). (Refer to Appendix 2.)
Even if the print interval is set at 1 to 40 points, the print
interval used with real time printing is automatically set to 80
points.
If you want to print with a print interval of 1 to 40 points, press
the PRINT button after measurement has stopped.
6.3.7 Setting the Print Mode
This mode is available when the 8992 PRINTER UNIT is
connected. Select whether to print measurement data as
waveform or numeric values.
Procedure
Status Screen
1. Press the
SET
button to display the Status Screen.
2. Move the flashing cursor to
Print Mode
and
use the
buttons to make a selection.
3. Press the
buttons to set the print interval (1 division =
80 points) when "Logging" is selected.