Hioki 8807-01 - 4.2 Operation Sequence (MEM)

34
_____________________________________________________________________
4.2 Operation Sequence ( MEM)
______________________________________________________________
Extended Status Screen
Refer to Chapter 2
.
Settings on the Status Screen
Time axis range
Recording length
Function
Printer recording format
Display layout
Select MEMORY (memory recorder
function).
Set the speed with which the input signal
waveform is captured.
Set the length of the data sample
for a single measurement.
Select the layout of the Waveform Screen
and for printing.
Select whether data is automatically saved.
Select whether measurement data is to be
printed as a waveform or numerically.
Select whether waveform data is to be
printed automatically.
Roll mode
Sequential save
Using channel
Use this function, if necessary.
Configure memory allocation for
measurement data.
Scrolls the waveform display if the time
axis is 10 ms/div to 5 min/div.
Segments memory into blocks, and records
a waveform in each block.
Refer to Section 4.8.3.
Input waveforms data is extrapolated and
displayed numerically. Refer to Section 4.9.
Requires connection of the optional 8992 PRINTER
UNIT.
Auto save
Press the SET button to display the
Status Screen.
SET
Settings on the Status Screen
Extended Status Screen
Extended Status Screen
Numerical Calculation Screen
Preparation
Auto-print
4.2 Operation Sequence (MEM)
Memory recorder operating procedures are described by the
following flowcharts.