Hioki 8807-01 - Setting the Display Clear Function (X-Y Only)

85
_____________________________________________________________________
5.3 Setting Items
______________________________________________________________
Flashing cursor
Flashing cursor
OFF
Overlays new waveforms on the previous waveforms.
ON
Clears the previous waveforms when measurement
starts.
5.3.8 Setting the Display Clear Function (X-Y
only)
This setting is possible when the X-Y Screen display format
is selected.
This setting determines whether any previous waveforms
displayed on the screen will be cleared when the
START
button is pressed to begin a new measurement. If previous
waveforms are not cleared, they are overlaid by the new
waveform.
Procedure
Status, Waveform Screen
1. Display the screen to be displayed.
2. Move the flashing cursor to
Display Clear
and set to on or
off using the
buttons.