Hioki 8807-01 - Operation Sequence (RMS)

92
_____________________________________________________________________
6.2 Operation Sequence (RMS)
______________________________________________________________
Refer to Chapter 2
Settings on the Status Screen
Time axis range
Recording length
Function
Printer recording format
Display layout
Select RMS (RMS recorder function).
Set the speed with which the input signal
waveform is captured.
Set the length of the data sample
for a single measurement.
Set the frequency to match that of the
signals to be measured.
Select the layout of the Waveform Screen
and for printing.
Select whether data is automatically saved.
Select whether measurement data is to be
printed as a waveform or numerically.
Select whether or not to print out
simultaneously with screen display.
Abnormal phenomena can be captured by
the trigger during measurement and
recorded by the Memory Recorder.
Requires connection of the optional 8992 Printer Unit.
Preparation
Auto save
Press the SET button to
display the Status Screen.
Refer to section 6.3.
SET
Settings on the Status Screen
Print
Frequency
Instantaneous
Waveform Recording
6.2 Operation Sequence (RMS)
RMS recorder operating procedures are described by the
following flowcharts.