Hioki 8807-01 - Page 117

93
_____________________________________________________________________
6.2 Operation Sequence (RMS)
______________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
APP
IND
Settings on the Trigger Screen
Settings on the Trigger Screen
Settings on the Channel Screen
Conversion ratio method
2-point method
Start measurement
Press the
START
button to start measurement.
To avoid inadvertent measurements, the
START
button
activation condition can be selected. Refer to Section 10.1.1,
for details.
Zero adjustment is performed automatically for every
measurement.
SET
Press the SET button to
display the Channel Screen.
Set the waveform display color,
voltage axis range, zero position,
etc. Refer to Chapter 7 for details.
The scaling function can be used to
convert the output voltage
from a sensor, for example, to a
physical property of the measured
object. Refer to Section 7.5.
Settings on the Channel Screen
Scaling Screen
SET
Press the SET button to
display the Trigger Screen.
Set the trigger source, type and
condition, and pre-trigger condition.
Refer to Chapter 8.
START
Channel Screen