176
_____________________________________________________________________
9.1 Using the A/B Cursors
______________________________________________________________
In recorder function and
RMS recorder function,
the maximum and
minimum values at the
position of cursor are
displayed.
For details, refer to
Appendix 2.
1234
9.1.3 Using the Trace Cursors
Used to read the time and voltage values at point where the
cursor crosses the waveform of the specified channel. A/B
cursor can be specified a different channel.
Procedure
Waveform Screen
1. Press the
DISP
button to display the Waveform Screen.
2. When position 1 shown in the figure below is selected to
SCRL
(scroll), use the buttons to set to
CSR
(cursor).
Pressing the
and buttons simultaneously also changes
setting.
3. Move the flashing cursor to position 2 and select + (trace
cursor).
4. Move the flashing cursor to position 3 and select the cursor
to be moved.
5. Move the flashing cursor to position 4 and select channel
using the
buttons.
When "All" is selected, the time and voltage values at the
cross points of cursor and all waveforms are displayed.
Move the A/B cursors using the
scrolling buttons to view
the display. Pressing the
buttons moves the cursors
faster.
To Next Page
Loading...
