Hioki 8807-01 - Operation Sequence (Input Channel Setting)

116
_____________________________________________________________________
7.2 Operation Sequence (Input Channel Setting)
______________________________________________________________
Analog Input
Waveform display graph
Voltage axis range
Waveform display color
Magnification/compressio
n ratio along the voltage
axis
Zero position
Input coupling
Waveform display color
Waveform display
position
Logic Input
Set the display color for the waveform.
Set which graph to display for each
channel waveform.
Set the voltage axis range for channel.
Set the input coupling for the input
signal.
Set the magnification/compression
ratio along the voltage axis for channel
to display or recording.
Set the zero voltage position.
Set the display position of the logic
waveform.
Set the display color for the waveform.
Low-pass filter
Set the low-pass filter.
Conversion ratio method
2-point method
The scaling function can be used to
convert the output voltage from a sensor,
for example, to a physical property of the
measured object. (Refer to Section 7.5)
Settings on the Channel Screen
Settings on the Channel Screen
SET
Settings on the Channel Screen
Settings on the Scaling Screen
Press the SET button to
display the Channel Screen.
Refer to section 7.3.
Refer to section 7.5.
7.2 Operation Sequence (Input Channel
Setting)