Hioki 8807-01 - Screen Copy; List Print

229
_____________________________________________________________________
11.6 Printing Procedure
______________________________________________________________
NOTE
Even if the gauge is set to the List & Gauge function, the gauge
is not printed out in the screen copy mode. The screen copy
function is not available during measurement.
NOTE
The list to be printed contains the setup conditions for the
acquired waveforms. Even if the settings are changed following
wave acquisition, the contents of the list remain unchanged. If
there is no waveform data, the list is not printed.
11.6.5 Screen Copy
11.6.6 List Print
Prints a copy of the display screen.
Before printing by the
COPY
button, "Output Device" on
the RS&COPY Screen must first be set to "Printer." Refer
to Section 10.3 for the setting procedure.
Procedure
All Screens
1. Display the desired screen.
2. Press the
COPY
button.
The settings for the various functions made with the Status,
Channel, System, Trigger Screens etc. can be printed out in
list format.
The contents are the same as the List in the List & Gauge
settings. (Refer to Section 11.2.3.)
Procedure
All Screens (excluding Waveform)
Press the
PRINT
button on the screen excluding Waveform
Screen.